80GPE VOE 14526511 EC700 Volvo Excavator Tooth

80GPE VOE 14526511 EC700 Volvo Excavator Tooth, Skid Steer Wheeled Loader Self-sharpening General purpose Bucket Teeth Fits Volvo, Bolt-on Side Pin Tooth Point, Replacement Volvo Loader Excavator Backhoe Digger Bucket Blade Teeth System, Volvo VTS bucket teeth 80GPE,  Precision Drop Forging Casting GET Spare Parts China Supplier

80GPE VOE 14526511 EC700 Volvo Excavator Tooth – Volvo Bucket Tooth Pins and Retainer 5-8GPE/15GPE/20GPE/30GPE/40GPE/55GPE/65GPE/80GPE/125GPE. Quality aftermarket G.E.T. (bucket teeth) for Caterpillar (CAT), JCB, Bobcat, Takeuchi, John Deere, Case, Komatsu, Kubota and many others including manufacturers such as Esko, Hensley, H&L for all your backhoe, loader, skid steer, grader, scraper and excavator bucket tooth (teeth) needs. Factory Direct We focus both on inner quality and also on surface finish. Due to our rich casting experience, we continuously improve our investment casting in every process, so that we can get very good surface quality.

Performance and reliability
– No hammers and no pry bars. You just need a socket or breaker bar wrench to install and remove the retention pin for quicker, safer tooth replacement.
– Multi-planed nose surfaces and matching pocket surfaces absorb loads from any angle, minimizing motion for longer system life. Doosan Excavator Parts Bucket Tooth 2713-1236RC
– Optimized tooth-to-nose-length ratio for better penetration and performance.
– Symmetrical design allows teeth to be flipped, with pin retention from either side for longer tooth life.
– Forged pin is never under load except during back-dragging,  and the rubber locks are not compressed when the pin is locked for long life and the rare need for replacement at change-outs. DH360 2713-00032RC Front End Loader Backhoe Bucket Tooth For Daewoo Doosan 360
– Rubber locks are held captive when the tooth is retained for security and protection from direct impact.

Both the design and fitment of the bucket teeth is very important to their lifespan, performance and application.

With the greater emphasis from a number of GET wholesalers being on price, some manufacturers have to reduce the quality of their products in order to meet these price demands. These reductions result in poorer quality of the cast steel, the fitment of the moulds and shorter heat treatment processes so they are not as hard or abrasion resistant.